| |
Bug Id: | CSCtz40435 |
Title: | L4 Port-range ACL does not work on EVC on whales |
|
Description: | Symptoms: The L4 port-range security ACL does not work on EVC.
Conditions: This symptom is seen when security ACL containing L4 port range operation that is applied on EVC. The behavior is not as expected. The same works on physical interface.
Workaround: Add support for L4 port range operation similar to the case of applying it on physical interface.
PSIRT Evaluation: The Cisco PSIRT has evaluated this issue and does not meet the criteria for PSIRT ownership or involvement. This issue will be addressed via normal resolution channels.
If you believe that there is new information that would cause a change in the severity of this issue, please contact psirt@cisco.com for another evaluation.
Additional information on Cisco's security vulnerability policy can be found at the following URL:
http://www.cisco.com/en/US/products/products_security_vulnerability_policy.html
|
|
Status: | Fixed |
|
Severity: | 2 Severe |
Last Modified: | 01-JUL-2015 |
|
Known Affected Releases: | 15.2(2)S |
|
Known Fixed Releases: | 15.2(2)S0.4, 15.2(2)S1, 15.2(4)S1c, 15.2(4)S2, 15.2(4)S3, 15.2(4)S3a, 15.2(4)S4, 15.2(4)S4a, 15.2(4)S5, 15.2(4)S6 |
|
|
| |
| |
Bug Id: | CSCug36858 |
Title: | MET consumption increases continuously and is not freed up |
|
Description: | Symptom: Traffic through the 3600 causes MET consumption to increase continuously.
Conditions: When traffic flows through an me3600, met consumption is increasing continuously. This eventually leads to met resources getting exhausted. The device could start throwing tracebacks and show unpredictable behavior. It could even eventually lead to crash of the box.
Workaround: There are no known workarounds. Increasing the mac aging helps mitigate the issue. However, it doesn't fix it and will only delay the failure.
Further Problem Description: met leak effecting multi cast functionality
|
|
Status: | Fixed |
|
Severity: | 2 Severe |
Last Modified: | 08-JUL-2015 |
|
Known Affected Releases: | 15.3(1)S1, 15.3(2)S1 |
|
Known Fixed Releases: | 15.3(2)S1b, 15.3(2)S1c, 15.3(2.19)S0.7, 15.3(3)S, 15.3(3)S1, 15.3(3)S1a, 15.3(3)S2, 15.3(3)S2a, 15.3(3)S3, 15.3(3)S4 |
|
|
| |
| |
Bug Id: | CSCuu99395 |
Title: | BGP Flap seen with 64k ingress policer |
|
Description: | Symptom: BGP packets may be dropped when 64k policer is configured on ingress
Conditions: Ingress class default policer with 64k Policer
Workaround: Increase the policer limit
Further Problem Description:
|
|
Status: | Fixed |
|
Severity: | 2 Severe |
Last Modified: | 12-JUL-2015 |
|
Known Affected Releases: | 15.4(3)S3.1 |
|
Known Fixed Releases: | 15.6(0.8)S |
|
|
| |
| |
Bug Id: | CSCuv00359 |
Title: | LAG data(ifType) is wrongly populating in IF-MIB for ME3800/3600. |
|
Description: | Symptom: In ifTable, ifType value is wrongly populating for lag in ME3800/3600 devices. For LACP enabled interfaces, ifType data should be 'ieee8023adLag'. But currently populating the data 'propVirtual'.
Conditions: NO CONDITION
Workaround: NA
Further Problem Description:
|
|
Status: | Fixed |
|
Severity: | 2 Severe |
Last Modified: | 22-JUL-2015 |
|
Known Affected Releases: | 15.4(3)S2.1 |
|
Known Fixed Releases: | 15.6(0.10)S |
|
|
| |
| |
Bug Id: | CSCtr79905 |
Title: | Error msg while detaching and reattaching the policy on evc |
|
Description: | Symptoms: Error message seen while detaching and reattaching a service policy on an EVC interface.
Conditions: The symptom is observed when detaching and reattaching the service policy on an EVC interface when port shaper is configured on the interface.
Workaround: A workaround is to not reuse the policy-map that is giving the error. Instead try to create a policy-map with a different name, copy the content over from the original policy-map, then try to attach the new policy to the target again. |
|
Status: | Fixed |
|
Severity: | 2 Severe |
Last Modified: | 26-JUL-2015 |
|
Known Affected Releases: | 15.1(3)S |
|
Known Fixed Releases: | 15.1(2)EY1, 15.1(3)MR, 15.1(3)MRA, 15.1(3)MRA1, 15.1(3)MRA3, 15.1(3)MRA4, 15.1(3)S2.1, 15.1(3)S3, 15.1(3)S5, 15.1(3)S5a |
|
|
| |
| |
Bug Id: | CSCua98902 |
Title: | Remote LFA FRR support for whales - fibidbnot getting initialized |
|
Description: | Symptoms: fibidb is not getting intialized.
Conditions: This symptom is observed when LFA FRR is configured in Cisco ME 3800x and ME 3600x switches.
Workaround: There is no workaround.
|
|
Status: | Fixed |
|
Severity: | 2 Severe |
Last Modified: | 29-JUL-2015 |
|
Known Affected Releases: | 15.2(2)S |
|
Known Fixed Releases: | 15.0(5.0)SG1, 15.0(5.0.26)SG, 15.1(1)IC66.17, 15.1(1)ICA4.16, 15.1(1)ICB29.1, 15.1(1)ICB40.1, 15.1(1)SY0.1, 15.1(1)SY1, 15.1(1)SY1.32, 15.1(1)SY1.55 |
|
|
| |
| |
Bug Id: | CSCut22886 |
Title: | ME3800 doesn't forward RSTP over EVC with dot1ad encapsulation |
|
Description: | Symptom: Me3800 drops the RSTP bpdu at the EVC level when EVC xconnect with dot1ad encapsulation
Conditions:
Workaround:
Further Problem Description:
|
|
Status: | Fixed |
|
Severity: | 2 Severe |
Last Modified: | 29-JUL-2015 |
|
Known Affected Releases: | 15.4(3)S1.1 |
|
Known Fixed Releases: | 15.4(3)S3.8, 15.5(2.19)S |
|
|
| |
没有评论:
发表评论